Anyone holding a ceramic implant cannot tell from the finished product which thermal processes lie behind its strength. In episode 129 of the podcast Queens & Sons of Dentistry, Torsten Burlage, owner of the production facility in which ceramic implants of the Neodent brand are made, explains step by step during a tour of the production how a pressed green part becomes a high-strength zirconia implant.
Why the pressed implant is 30 per cent too large
After powder injection moulding, the implant already has its final geometry, but is still around 30 per cent larger than the later product. The reason lies in the material itself: the processed feedstock consists of zirconia powder coated with wax and plastic. These binders make the material flowable during injection, but do not belong in the finished implant. They have to be removed completely before the ceramic can reach its final strength.
Debinding: five days in the furnace
The first thermal step is what is known as debinding – a process that takes five days in this production facility. The waxes and plastics are completely dissolved out by means of temperature: the entire binder system is evaporated or burned off in the furnace until only the pure ceramic structure remains. Burlage describes the condition of the parts after these five days very vividly: they are pure ceramic parts that have not yet been sintered together and whose structure is still rather fragile – but free of any waxes and plastics.
The furnaces are loaded using so-called sintering towers. The products are stacked on their plates, and a single tower can have up to nine levels. The material of the plates is remarkable: they are made of aluminium oxide, because the high process temperatures call for a material whose temperature resistance lies slightly above that of zirconia. On average, 500 to 550 parts fit on each plate; a complete debinding load comprises around 18,000 to 24,000 parts, according to Burlage.
Sintering: shrinkage by 30 per cent
After debinding, the products are transferred to the sintering furnaces, which can hold up to 4,500 parts at a time. The sintering process itself, at around one and a half days, is considerably shorter than debinding. In this step the products shrink by 30 per cent – precisely the excess size created during injection moulding by the binders. Afterwards, the high-strength ceramic parts are ready.
A vivid comparison is drawn in the podcast: the procedure resembles a cashmere jumper shrinking in the washing machine – with one decisive difference, however, since the shrinkage occurs in an absolutely uniform size ratio. It is precisely this predictability that is the prerequisite for the geometry created during injection moulding ultimately arriving dimensionally accurate in the end product.
Cleanliness as a side effect of temperature
One aspect that Burlage particularly highlights is the purity of the parts after the furnace process: after temperatures of 1,500 degrees Celsius, nothing remains other than the ceramic itself. The products accordingly emerge from the furnaces already very clean – a good starting position for the subsequent hard machining, which in this facility is deliberately carried out dry, that is, without oil or lubricants.
It is also striking how compact the entire process chain turns out to be. During the tour, the observation is shared that considerably more work steps had been expected – in fact, this area essentially contains three machines and two furnaces. The combination of injection moulding, five days of debinding and one and a half days of sintering shows that the quality of a ceramic implant depends less on many manual steps than on a few thermal processes that are precisely mastered.